I was doing what Ildar did and I did attaching quickly. :( On Fri, Nov 6, 2015 at 4:34 PM, Till Westmann <[email protected]> wrote:
> Thanks for both replies! > > @Ildar: When you added the JVM parameters for the CC or NC, how did you go > about attaching at the “right” point in time? Did you stop the JVM waiting > for the connection or were you “attaching quickly”? > > Thanks again, > Till > > > On 5 Nov 2015, at 22:47, Murtadha Hubail wrote: > > I think the easiest way without having to attach a remote debugger is to >> execute their queries manually in the web interface after running >> AsterixHyracksIntegrationUtil in debugging mode. When it is time to execute >> kill_cc_nc.sh, just kill -9 the AsterixHyrackIntegrationUtil process. Then >> run AsterixHyrackIntegrationUtil again and it will perform the recovery. >> >> -Murtadha >> >> On Nov 5, 2015, at 10:14 PM, Ildar Absalyamov <[email protected]> >>> wrote: >>> >>> Till, >>> >>> The only way I found to debug it sometime ago when I needed was to add >>> remote debugger into CC/NC JVM properties of asterix-configuration.xml >>> (asterix-installer/src/main/resources/conf), which is used to setup mini >>> cluster to tests. >>> >>> On Nov 6, 2015, at 11:07, Till Westmann <[email protected]> wrote: >>>> >>>> Hi, >>>> >>>> I’m wondering how people go about running the code that is executed by >>>> one of the RecoveryIT in the debugger. >>>> I imagine that there are number of ways to do that. >>>> If you have done this at some point, could you describe how you did >>>> that? >>>> >>>> Thanks, >>>> Till >>>> >>> >>> Best regards, >>> Ildar >>> >>>
