[dpdk-dev] [PATCH] net/liquidio:fix Unable to update lio_dev->linfo.link var When I was using VPP +dpdk-18.02+liqudio CN23xx, I encountered such a bug. When VPP called dpdk_device_start to initialize DPDK liqudio drive, I found that initialization failed. The reason for the failure is that VF MTU > PF MTU, but PF MTU has been modified to 9600 (> VF MTU). Finally, I am location that DPDK liqudio drive cannot get the correct PF driver to liqudio network card. It is due to the fact that when VPP calls dpdk_device_start to initialize DPDK liqudio drive, this time, lio_dev->linfo. Link var already exists in the old value, not empty. Cause lio_dev - > linfo. Link. Link_status64 != 0 statement is set up, and the link info is stopped directly to liqudio card, resulting in no get accurate pf mtu. I did a test model to reproduce the bug, which is to add rte_eth_dev_set_mtu(portid, vf_mtu) to the rte_eth_dev_start function when using dpdk-18.02+liqudio CN23xx+l2fwd. You need to make sure that 1500 < vf_mtu < pf_mtu will be available. At this time, you will have net_liovf[04:00.3]ERROR: lio_dev_mtu_set() VF MTU should be >= 68 and <= 1500. Such a mistake.

[yaochuhong]

Signed-off-by: yaochuhong <y...@panath.cn>
---
 drivers/net/liquidio/lio_ethdev.c | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/drivers/net/liquidio/lio_ethdev.c 
b/drivers/net/liquidio/lio_ethdev.c
index 0e0b5d8..50743c7 100644
--- a/drivers/net/liquidio/lio_ethdev.c
+++ b/drivers/net/liquidio/lio_ethdev.c
@@ -1405,6 +1405,9 @@ struct rte_lio_xstats_name_off {
        /* Configure RSS if device configured with multiple RX queues. */
        lio_dev_mq_rx_configure(eth_dev);
 
+       /* Before update the link info, must set linfo.link.link_status64 to 0. 
*/
+       lio_dev->linfo.link.link_status64 = 0;
+
        /* start polling for lsc */
        ret = rte_eal_alarm_set(LIO_LSC_TIMEOUT,
                                lio_sync_link_state_check,
-- 
1.8.3.1