Bruce, We have a set of patches which add support to a couple of new Broadcom PCI devices. Should I use the dpdk-next-net/rel_16_07 to push them out? Let me know if there is any other way to do this.
Thanks On Thu, Jun 16, 2016 at 1:51 PM, Ajit Khaparde <ajit.khaparde at broadcom.com> wrote: > > On Thu, Jun 16, 2016 at 9:24 AM, Bruce Richardson < > bruce.richardson at intel.com> wrote: > >> On Wed, Jun 15, 2016 at 02:23:00PM -0700, Stephen Hurd wrote: >> > The bnxt poll mode library (librte_pmd_bnxt) implements support for >> > Broadcom NetXtreme C-Series. These adapters support Standards- >> > compliant 10/25/50Gbps 30MPPS full-duplex throughput. >> > >> > Information about this family of adapters can be found in the >> > NetXtreme Brand section https://goo.gl/4H7q63 of the Broadcom web >> > site http://www.broadcom.com/ >> > >> > With the current driver, allocated mbufs must be large enough to hold >> > the entire received frame. If the mbufs are not large enough, the >> > packets will be dropped. This is most limiting when jumbo frames are >> > used. >> > >> >> Applied to dpdk-next-net/rel_16_07 >> >> On apply I got conflicts with the nic overview document, so please check >> the >> resulting information in that document is correct in the next-net tree. >> I also added a very short entry to the release notes for this new driver >> as >> part of patch 1, since that was missing. Please also check that for >> correctness >> and send on any additional comments/corrections you want on that. >> > Thanks Bruce. I had a cursory glance ?and it looked good. > We will update the > ?m? further > if necessary. > ? > > >> Thanks for all the work on this driver. >> >> Regards, >> /Bruce >> > >