BUILD SUCCESSFUL! YEEHAA!
Do you me to recap the few issues I have faced as a "newbie"? Maurice -----Message d'origine----- De : Maurice Amsellem [mailto:maurice.amsel...@systar.com] Envoyé : jeudi 26 septembre 2013 17:42 À : dev@flex.apache.org Objet : RE: Building the SDK from git Thanks, that's really helpful. I understand I launch the general build.xml the first time only, and then only need to run the build.xml for the project I am working on (eg. experimental/build.xml) which will compile rather quickly. Is that correct ? Maurice -----Message d'origine----- De : Justin Mclean [mailto:jus...@classsoftware.com] Envoyé : jeudi 26 septembre 2013 17:04 À : dev@flex.apache.org Objet : Re: Building the SDK from git Hi, > Please can you share how you proceed to compile when you make even small > changes to the code and would like to test them. > Are you using an IDE at all ? I normally use Flash Builder to edit files (but sometimes vi from the command line) and I normally compile using ant from the command line. I have the entire SDK as a single general project, that way it works nicely when debugging, but there's probably other ways of setting it up. Ant can be run from within Flash Builder, right right click on a build.xml file and select Run As then "Ant build" (which will do an ant main), if you select "Ant build..." you can specify which target to run. I'd assume other IDE's have the same feature. Once you have an SDK set up you can compile each project in framework/projects as you make changes, they compile reasonable quickly (under a min for each one). Just be careful is using Flash Builder this was as sometime (not often) it can cache the pervious versions, if so just swap the project SDK to another then back again and that seem to clear the cache. Thanks, Justin
