David / Jason
The version number for tranql/trunk/tranql/ was incorrect. I've corrected the version numbers for
connector and tranql to 1.3-SNAPSHOT and 1.4-SNAPSHOT accordingly.
David Jencks wrote:
I looked this over and applied it.
It appears that the versions in project.xml (and now the poms) are lower
than those expected by geronimo, e.g. tranql version is 1.3-SNAPSHOT but
geronimo is using 1.4-SNAPSHOT, connector version is 1.2-SNAPSHOT but
geronimo is using 1.3-SNAPSHOT.
Does anyone know what is going on and where the tranql snapshots with
the higher numbers are from?
thanks
david jencks
On Jul 4, 2006, at 1:16 AM, Jason Dillon wrote:
Attached is an updated diff with the same version numbers as
requested. I just used the versions from the project.xml... someone
should double check.
Spits out:
/Users/jason/.m2/repository/org/tranql/tranql-connector/1.2-SNAPSHOT/tranql-connector-1.2-SNAPSHOT.jar
/Users/jason/.m2/repository/org/tranql/tranql-connector-derby-common/1.2-SNAPSHOT/tranql-connector-derby-common-1.2-SNAPSHOT.jar
/Users/jason/.m2/repository/org/tranql/tranql-core/1.3-SNAPSHOT/tranql-1.3-SNAPSHOT.jar
/Users/jason/.m2/repository/org/tranql//tranql-connector-derby-client-local/1.2-SNAPSHOT/tranql-connector-derby-client-local-1.2-SNAPSHOT.rar
/Users/jason/.m2/repository/org/tranql//tranql-connector-derby-client-xa/1.2-SNAPSHOT/tranql-connector-derby-client-xa-1.2-SNAPSHOT.rar
/Users/jason/.m2/repository/org/tranql//tranql-connector-derby-embed-local/1.2-SNAPSHOT/tranql-connector-derby-embed-local-1.2-SNAPSHOT.rar
/Users/jason/.m2/repository/org/tranql//tranql-connector-derby-embed-xa/1.2-SNAPSHOT/tranql-connector-derby-embed-xa-1.2-SNAPSHOT.rar
/Users/jason/.m2/repository/org/tranql//tranql-connector-ra/1.2-SNAPSHOT/tranql-connector-ra-1.2-SNAPSHOT.rar
--jason
<tranql-m2-v2.diff>
On Jul 3, 2006, at 10:31 PM, Jason Dillon wrote:
Not sure who to send this too... so I'm posting it here.
Attached is the start of a m2 build for TranQL. This builds the core
(tranql), connector and derby bits. Had to add a separate
connector-ra to build the rar, as the vendor bits need the jar for
depends and I'm not sure how to make m2 build that configuration.
I set this up to all build in one cycle, using org.tranql and
2.0-SNAPSHOT... if you guys wanna keep the versions different for the
vendor bits then some small changes need to be made... though IMO its
easier to maintain the tree with one version.
Still needs the other vendors hooked up, but those should be
relatively simple to create based on the derby poms.
Cheers,
--jason
<tranql-m2.diff>
