Ray Mattingly created HBASE-28453: ------------------------------------- Summary: Support a middle ground between the Average and Fixed interval rate limiters Key: HBASE-28453 URL: https://issues.apache.org/jira/browse/HBASE-28453 Project: HBase Issue Type: Improvement Affects Versions: 2.6.0 Reporter: Ray Mattingly Attachments: Screenshot 2024-03-21 at 2.08.51 PM.png, Screenshot 2024-03-21 at 2.30.01 PM.png
h3. Background HBase quotas support two rate limiters: a "fixed" and an "average" interval rate limiter. h4. FixedIntervalRateLimiter The fixed interval rate limiter is simpler: it has a TimeUnit, say 1 second, and it refills a resource allotment on the recurring interval. So you may get 10 resources every second, and if you exhaust all 10 resources in the first millisecond of an interval then you will need to wait 999ms to acquire even 1 more resource. h4. AverageIntervalRateLimiter The average interval rate limiter, HBase's default, allows for more flexibly timed refilling of the resource allotment. Extending our previous example, say you have a 10 reads/sec quota and you have exhausted all 10 resources within 1ms of the last full refill. If you request 1 more read then, rather than returning a 999ms wait interval indicating the next full refill time, the rate limiter will recognize that you only need to wait 99ms before 1 read can be available. After 100ms has passed in aggregate since the last full refill, it will support the refilling of 1/10th the limit to facilitate the request for 1/10th the resources. h3. The Problems with Current RateLimiters The problem with the fixed interval rate limiter is that it is too strict from a latency perspective. It results in quota limits to which we cannot fully subscribe with any consistency. The problem with the average interval rate limiter is that, in practice, it is far too optimistic. For example, a real rate limiter might limit to 100MB/sec of read IO per machine. Any multigets that come in will require only a tiny fraction of this limit; for example, a 64kb block is only 0.06% of the total. As a result, the vast majority of wait intervals end up being tiny — like <5ms. This can actually cause an inverse of your intention, where setting up a throttle causes a DDOS of your RPC layer via continuous throttling and ~immediate retrying. I've discussed this problem in https://issues.apache.org/jira/browse/HBASE-28429 and proposed a minimum wait interval as the solution there; after some more thinking, I believe this new rate limiter would be a less hacky solution to this deficit so I'd like to close that Jira in favor of this one. See the attached chart where I put in place a 10k req/sec/machine throttle for this user at 10:43 to try to curb this high traffic, and it resulted in a huge spike of req/sec due to the throttle/retry loop created by the AverageIntervalRateLimiter. h3. PartialIntervalRateLimiter as a Solution I've implemented a RateLimiter which allows for partial chunks of the overall interval to be refilled, by default these chunks are 10% (or 100ms of a 1s interval). I've deployed this to a test cluster at my day job and have seen this really help our ability to full subscribe to a quota limit without executing superfluous retries. See the other attached chart which shows a cluster undergoing a rolling restart from using FixedIntervalRateLimiter to my new PartialIntervalRateLimiter and how it is then able to fully subscribe to its allotted 25MB/sec/machine read IO quota. -- This message was sent by Atlassian Jira (v8.20.10#820010)