On Tuesday 18 September 2001 10:50 am, Farag, Hany M (Hany) wrote: Did you re-run buildconf? Ryan > Here's what i did: > . created the config.m4 files within module one and two directories under > modules. > . ./config --enable-so --enable-one --enable-two > . make > . make install > . ./httpd -l > But could not see that mod_one and mod_two listed. > What did i do wrong? > > Thanks > Hany > > -----Original Message----- > From: Ryan Bloom [mailto:[EMAIL PROTECTED]] > Sent: Tuesday, September 18, 2001 11:00 AM > To: [EMAIL PROTECTED]; Farag, Hany M (Hany); '[EMAIL PROTECTED]' > Subject: Re: HOW TO BUILD APACHE 2.0 WITH MORE THAN ONE MODULE(MODULES > WRI ITEN BY OTHER NON-APACHE DEVELOPERS) > > > On Tuesday 18 September 2001 07:02 am, Farag, Hany M (Hany) wrote: > > --with-module only accepts one module, and you can't add more. I keep > meaning > to go in and fix that, but I haven't had time recently. > > I would suggest just creating a config.m4 file for your own modules, and > copying > the files into a subdirectory of modules/. This is very clean, and then > you can do --enable-mod_one --enable-mod_two, etc. > > config.m4 is a very simple file to learn to write. > > Ryan > > > Hi, > > How do i configure and build apache with 2 or more modules of my own?(is > > it > > > possible?) > > I know for one module you can do it with the following command : > > ./configure --enable-so --with-module=one --enable-mods-shared=mod_one.so > > > > Thanks > > Hany -- ______________________________________________________________ Ryan Bloom [EMAIL PROTECTED] Covalent Technologies [EMAIL PROTECTED] --------------------------------------------------------------
