Hi both, Thank you very much . But in which directory to run the ant clean-eclipse eclipse command ? I check out use this command svn checkout http://svn.apache.org/repos/asf/lucene/dev/trunk lucene_trunk So should I run the command in the lucene_trunk dir or lucene_trunk/Solr dir ? and as Jack say "refresh" the project , does the project refer to lucene_trunk/Solr project imorted in eclipse ?
------------------ 原始邮件 ------------------ 发件人: "Jack Krupansky"<[email protected]>; 发送时间: 2012年9月28日(星期五) 晚上11:53 收件人: "dev"<[email protected]>; 主题: Re: 回复：build solr source Thank you! -- Jack Krupansky From: Uwe Schindler Sent: Friday, September 28, 2012 11:30 AM To: [email protected] Subject: RE: 回复：build solr source Since 2 hrs there is now also „ant clean-eclipse“, so after checkout only “ant clean-eclipse eclipse” would do a clean setup. No resolve/clean-jars needed, as this is all done automatically. ----- Uwe Schindler H.-H.-Meier-Allee 63, D-28213 Bremen http://www.thetaphi.de eMail: [email protected] From: Jack Krupansky [mailto:[email protected]] Sent: Friday, September 28, 2012 5:04 PM To: [email protected] Subject: Re: 回复：build solr source I always run “ant clean clean-jars resolve eclipse” after checkout, delete the eclipse-build directory, then do “refresh” in eclipse. -- Jack Krupansky From: 心如止水 Sent: Friday, September 28, 2012 10:52 AM To: dev Subject: 回复：build solr source Hi all, when I check the solr source out , and run ant eclipse command and then import into eclipse ,there are some error occur : Analyzer cannot be resolved to a type and AbstractAllGroupHeadsCollector cannot be resolved and Type _TestUtil cannot be resolved ? someone can tell me how to solve this ?
