On 2017-08-25 16:53, marko kiiskila wrote:
On Aug 25, 2017, at 8:39 AM, Christopher Collins <[email protected]>
wrote:
Hi Jyothi,
On Fri, Aug 25, 2017 at 12:10:50PM +0000, [email protected] wrote:
[...]
After we run the application, cant able to get the shell prompt as
mentioned by you through minicom. With Arduino IDE and the arduino
EDBG boot loader we can able to communicate with the board. But with
the arduino_boot and arduino_blinky targets in mynewt cant able to
communicate.
Did you set the BSP_ARDUINO_ZERO_PRO syscfg setting to 1, as indicated
in https://mynewt.apache.org/latest/os/tutorials/arduino_zero/? That
step is easy to miss.
Also note that blinky does not have shell compiled in. It’s a very
simple
app which just blinks an LED. Try the app slinky instead; that one has
shell
enabled.
Hi marko,
In this tutorial it is mentioned that we can enable the console and
shell in blinky application.
https://mynewt.apache.org/latest/os/tutorials/blinky_console/
I followed all the steps but didn't able to achieve it.
