Hi sir:
Nice to meet you, We are from Bosch Sensortec, now we are using Mynewt
Core 1.5.0 on Nordic nRF52840, we have question about the I2C communication.
As you can see from the picture below, the overall result of I2C communication
is successful, but there are a lot of NAK before a ACK read. this is due to
the abnormal behavior of SCL.
Do you have any suggestion on this? Do we need to change some
configuration/Mynewt Core code to fix this?
[cid:[email protected]]
The anolog waveform of I2C communication is also not so good(shown as below),
can we change some configuration/Mynewt Core code to improve it?
[cid:[email protected]]
Best regards,
Bingjing GE
BST/ESA3.2
Tel. +86 21 2218-1915
