Hi All,
As already mentioned in the previous e-mail regarding the lps33hw driver and LPS22HB sensor, I would like to point out that also the LPS22HH sensor is already supported by the lps33thw driver since the registers map and the functionalities are the same, only the package type changes (one is for general purpose the other is for water proof application) and this does not impact the driver's source code If we wanted to declare in mynewt also the support for the sensors LPS22HB and LPS22HH how would you suggest to proceed: - Rewriting the drivers for LPS22HB and LPS22HH starting from the LPS33HW and LPS33THW drivers respectively and pushing that as new drivers (in this case the code will be replicated just changing the API name) (I think it's not a the best way) ? or - Adding in the drivers documentation of LPS33HW and LPS33THW the support of the LPS22HB and LPS22HH sensors ? Best Regrds, Mario -------- Forwarded Message -------- Subject: lps33hw sensor driver Date: Fri, 12 Apr 2019 17:20:56 +0200 From: Mario TESI <[email protected]><mailto:[email protected]> To: [email protected]<mailto:[email protected]> Hi All, I was trying to figure out how to organize the work to add support to MyNewT for the new MEMS sensors produced by STMicroelectronics and I came across the lps33hw driver (hw / driver / sensors / lps33hw) which actually also supports the part number LPS22HB, in fact both devices have - the same Who am I - same functionalities - same register map and bitmap these devices differ only by the case type because LPS33HW is for water proof application while LPS22HB is for generic usage. Would it be possible to indicate in the documentation that the lps33hw driver into the distro supports both LPS33HW and LPS22HB devices (?) Best Regards, Mario
