Hi Alan,
On Wed, Feb 01, 2017 at 11:05:23PM +0000, Alan Graves wrote:
> Hi,
>
> I've spent some time trying to get nRF52832 DK running the 'blehci' code
> communicating with Xubuntu 16.10 (under VMware) with not much luck.
I just ran the latest blehci from develop with the following setup:
* BlueZ 5.39
* Ubuntu 16.04 (Xenial)
* nRF52832 DK
I didn't notice any issues when I tried. I'm afraid I don't see
anything wrong with the steps you follows. Maybe one of the following
hints will help:
* Make sure the two flow control pins (RTS / CTS) are attached.
* Try killing btattach and restarting it. When you do this, you should
see BlueZ send the host init sequence in btmon (starting with a Reset
command).
The btattach step is required because the BlueZ host doesn't seem to
interpret the no-op event as a controller reset. You have to explicitly
tell the host to reset the controller.
Hopefully this gets you a little closer to a solution. If you're still
seeing the same issue, just let me know and we can debug it further.
Thanks,
Chris
