Are you running any PX4IO drivers or RC input? -----Original Message----- From: Oleg Evseev [mailto:ev.m...@gmail.com] Sent: Wednesday, November 11, 2020 3:09 AM To: dev@nuttx.apache.org Subject: Serial console strange behaviour
Hi, Custom board stm32f7, PX4 based project - moved from NuttX 8.2 to 10.0.0. If serial dev console (CONFIG_USART6_SERIAL_CONSOLE=y) is used, it works: prints all corresponding output on boot, but then "nsh> " is shown only when I start typing in putty. "ls" command shows only the first output line. Other lines are shown only if I type at least one symbol. I tried with and without CONFIG_USART6_RXDMA - same result. USB CDC ACM console works OK. Any thoughts on what can cause such behavior? --- With best regards, Oleg
