On Sat, Jul 1, 2023 at 8:32 PM Milan Obuch wrote: > Maybe it has something to do I am still using 12.0.0 sources
Can you try with master? 12.2.0 will show up soon :-) > maybe it > has something to do with the way I am using FreeBSD as host OS I am also working on FreeBSD that example worked on ESP32-S2 + NuttX 12.1.0 + FreeBSD 13.2-RELEASE :-) Flashing is done over internal ESP32-S2 USB-SerialJtag (onboard connector). Console is done with external UART-to-USB adapter attached to pins selected in the CONFIG. You can try the UART-to-USB setup on something that you are sure to work, then update UART pin mapping for ESP32-S2 build and it should work :-) Note that only GND, VCC, RX, TX signals are needed, no control lines as you need to reset and switch to bootloader by hand. > some more investigation is needed. This all takes some time, so do not > expect anything some time soon. I am still in testing phase No worries, take your time, and enjoy learning new stuff :-) -- CeDeROM, SQ7MHZ, http://www.tomek.cedro.info
