This patch is not fully baked. I'm testing a fix now that would need to be applied on top of it.
--Justin On May 10, 2011, at 11:08 AM, Ben Pfaff <[email protected]> wrote: > From: Justin Pettit <[email protected]> > > The proper way to switch the networking back-end is to use the > "xe-switch-network-stack" command rather than directly modifying > "/etc/xensource/network.conf". Use that method in the spec file. > --- > xenserver/openvswitch-xen.spec | 14 ++------------ > 1 files changed, 2 insertions(+), 12 deletions(-) > > diff --git a/xenserver/openvswitch-xen.spec b/xenserver/openvswitch-xen.spec > index 97bf99c..de702ad 100644 > --- a/xenserver/openvswitch-xen.spec > +++ b/xenserver/openvswitch-xen.spec > @@ -226,12 +226,7 @@ done > > if [ "$1" = "1" ]; then # $1 = 2 for upgrade > # Configure system to use Open vSwitch > - echo vswitch > /etc/xensource/network.conf > - > - printf "\nYou MUST reboot the server NOW to complete the change to\n" > - printf "Open vSwitch. Attempts to modify networking on the server\n" > - printf "or any hosted VM will fail until after the reboot and could\n" > - printf "leave the server in a state requiring manual recovery.\n\n" > + xe-switch-network-backend vswitch > else > > mode=$(cat /etc/xensource/network.conf) > @@ -310,12 +305,7 @@ if [ "$1" = "0" ]; then # $1 = 1 for upgrade > rmdir -p /usr/lib/openvswitch/xs-saved 2>/dev/null > > # Configure system to use bridge > - echo bridge > /etc/xensource/network.conf > - > - printf "\nYou MUST reboot the server now to complete the change to\n" > - printf "standard Xen networking. Attempts to modify networking on the\n" > - printf "server or any hosted VM will fail until after the reboot and\n" > - printf "could leave the server in a state requiring manual recovery.\n\n" > + xe-switch-network-backend bridge > fi > > %files > -- > 1.7.4.4 > _______________________________________________ dev mailing list [email protected] http://openvswitch.org/mailman/listinfo/dev
