Hello , no it does not work. eth1 without openvswitch works with promisc and not promisc tcpdump on eth1 in openvswitch bridge , i can see arp traffic and broadcast ( from externe to eth1 ) without response from eth1
in dmesg , not problem with HW and openvswitch ? eth1: intr type 3, mode 0, 2 vectors allocated eth1: NIC Link is Up 10000 Mbps 8021q: adding VLAN 0 to HW filter on device eth1 Regards, Nicolas. 2011/5/11 Jesse Gross <[email protected]> > On Wed, May 11, 2011 at 6:51 AM, nicolas prochazka > <[email protected]> wrote: > > Hello > > I'm using openvswitch 1.1.0 + kernel 2.6.38 with a simple bridge brE ( > > eth1 ) . > > In Real Hardware Test : ok > > In virtualBox with AMD / intel virtualNetwork card : ok > > in vmware ESX ( with Intel E1000 or VXMNET3 ) : not ok > > no traffic, no msg in dmesg, no message in openvswitch log > > if I stop openvswitch and if I'm using eth1 , all seems to be normal ( > > traffic ) with e1000 and vmxnet3. > > So do you have some information about that ? > > I believe that this should work. What do you see if you run tcpdump > on the interface? Is it all traffic or just some? Does it make a > difference if you put the interface in promiscuous mode when not using > Open vSwitch? >
_______________________________________________ dev mailing list [email protected] http://openvswitch.org/mailman/listinfo/dev
