On Thu, Sep 13, 2012 at 12:01:44PM +0900, Simon Horman wrote: > On Wed, Sep 12, 2012 at 12:09:41PM -0700, Ben Pfaff wrote: > > On Wed, Sep 12, 2012 at 05:44:32PM +0900, Simon Horman wrote: > > > By passing a flow to the action parser the pre-requisites > > > of set-feild actions will be checked. If the flow is NULL, > > > for instance in test code such as ofctl_parse_ofp11_instructions(), > > > then the check is skiped, as it always was before this change. > > > > > > Unfortunately I don't think that this check is correct as > > > it does not take into account other actions actions that may > > > be applied before the load action, e.g. vlan push/pop, which may > > > affect the pre-requisites. > > > > > > I believe that in its current form there is scope for both false positives > > > (not so bad, perhaps) and false negatives (pretty bad). I would welcome > > > some input on if these concerns are valid and if so how they may be > > > overcome. > > > > When I've thought about this problem before, I wasn't able to come up > > with an example of when the prerequisite check would be wrong. Do you > > have an example? > > I would very much like for this not to be a problem. > But here are examples that I am concerned about.
Hi Ben, do you have any thoughts on this? > # MPLS false negative > > 1. Packet with no MPLS header arrives > 2. Push MPLS action is applied > 3. Set-Field:MPLS_LABEL action is applied > > The pre-requisite for 3 is Eth Type 0x8847 or 0x8848, > but that isn't true until 2 is applied. > > > # MPLS false positive > > 1. Packet with single MPLS header arrives > 2. Pop MPLS action is applied > 3. Set-Field:MPLS_LABEL action is applied > > The pre-requisite for 3 is Eth Type 0x8847 or 0x8848, > which is true at 1 but not after 2 is applied. > > > # VLAN false positive > > 1. Ppacket without VLAN header arrives > 2. Push VLAN action is applied > 3. Set-Field:VLAN_PCP is applied > > The pre-requisite for 3 is that VLAN_VID!=NONE, > but this isn't true until 2 is applied. > > > # VLAN false negative > > 1. Packet with single VLAN header arrives > 2. Pop VLAN action is applied > 3. Set-Field:VLAN_PCP is applied > > The pre-requisite for 3 is that VLAN_VID!=NONE, > which is true at 1, but not after 2 is applied. > > _______________________________________________ > dev mailing list > dev@openvswitch.org > http://openvswitch.org/mailman/listinfo/dev > _______________________________________________ dev mailing list dev@openvswitch.org http://openvswitch.org/mailman/listinfo/dev
