Thanks, I applied this.
On Fri, Jun 28, 2013 at 1:41 AM, Rajahalme, Jarno (NSN - FI/Espoo) <jarno.rajaha...@nsn.com> wrote: > Now "make modules_install" works for me too, thanks. > > Jarno > > On Jun 28, 2013, at 3:26 , ext Jesse Gross wrote: > >> The Open vSwitch kernel module now has dependencies on symbols >> exported by other kernel modules (currently just for GRE). In >> order for it to load, the dependencies must be correctly resolved >> ahead of time. This runs depmod as part of the module installation >> process and updates the installation instructions. >> >> Reported-by: Justin Pettit <jpet...@nicira.com> >> Signed-off-by: Jesse Gross <je...@nicira.com> >> --- >> INSTALL | 13 ++++--------- >> datapath/linux/Makefile.main.in | 1 + >> 2 files changed, 5 insertions(+), 9 deletions(-) >> >> diff --git a/INSTALL b/INSTALL >> index 4749e30..0ff237c 100644 >> --- a/INSTALL >> +++ b/INSTALL >> @@ -209,15 +209,15 @@ Prerequisites section, follow the procedure below to >> build. >> 6. Run "make install" to install the executables and manpages into the >> running system, by default under /usr/local. >> >> -7. If you built kernel modules, you may load them with "insmod", e.g.: >> +7. If you built kernel modules, you may install and load them, e.g.: >> >> - % insmod datapath/linux/openvswitch.ko >> + % make modules_install >> + % /sbin/modprobe openvswitch >> >> - You may need to specify a full path to insmod, e.g. /sbin/insmod. >> To verify that the modules have been loaded, run "/sbin/lsmod" and >> check that openvswitch is listed. >> >> - If the "insmod" operation fails, look at the last few kernel log >> + If the "modprobe" operation fails, look at the last few kernel log >> messages (e.g. with "dmesg | tail"): >> >> - The message "openvswitch: exports duplicate symbol >> @@ -264,11 +264,6 @@ Prerequisites section, follow the procedure below to >> build. >> you do not understand what this means or do not know if your driver >> will work, do not set this. >> >> - Once you verify that the kernel modules load properly, you should >> - install them: >> - >> - % make modules_install >> - >> 8. Initialize the configuration database using ovsdb-tool, e.g.: >> >> % mkdir -p /usr/local/etc/openvswitch >> diff --git a/datapath/linux/Makefile.main.in >> b/datapath/linux/Makefile.main.in >> index 2e445ac..88f144c 100644 >> --- a/datapath/linux/Makefile.main.in >> +++ b/datapath/linux/Makefile.main.in >> @@ -71,6 +71,7 @@ default: >> >> modules_install: >> $(MAKE) -C $(KSRC) M=$(builddir) modules_install >> + depmod `sed -n 's/#define UTS_RELEASE "\([^"]*\)"/\1/p' >> $(KSRC)/include/generated/utsrelease.h` >> endif >> >> # Much of the kernel build system in this file is derived from Intel's >> -- >> 1.8.1.2 >> > X-CudaMail-Whitelist-To: dev@openvswitch.org _______________________________________________ dev mailing list dev@openvswitch.org http://openvswitch.org/mailman/listinfo/dev
