what is also missing from the pdf is that the EP-CBUSB10PFL01 usb from mouser plugs into the corner white header cn16 under the dual stack usb that is on the corner of the board.
On Mon, Nov 17, 2025 at 12:45 AM Harry Hsiung <[email protected]> wrote: > pinout for the ftdi cable is on the amazon site for the ftdi cable > there wasn't a pinout description in the upxtreme flash pdf. > > 6 pin colored cable with black connector > > pin1 black is gnd > pin 4 orange is TXM > pin 5 Yellow is RCV > > you will need to match up to the 3 pin red white and black wire cable on > the above EP-CBUSB10PFL01 from mouser > black is gnd > red is RCV > white is TXM > > Harry Hsiung > > On Mon, Nov 17, 2025 at 12:39 AM Harry Hsiung <[email protected]> wrote: > >> Forgot the ftdi cable. There are lots of FT232R 3.3v usb cables on amazon >> https://www.amazon.com/ft232r-usb-uart/s?k=ft232r+usb+uart >> >> >> >> On Mon, Nov 17, 2025 at 12:28 AM Harry Hsiung <[email protected]> >> wrote: >> >>> You can get this on mouser which carries cables for aaeon platforms >>> EP-CBUSB10PFL01 AAEON UP | Mouser >>> <https://www.mouser.com/ProductDetail/AAEON-UP/EP-CBUSB10PFL01?qs=%2Fha2pyFadujIhdWT%2FBglH%252B8eLhJc3tYwKVNFRQzH3zKWZ4kE8rH3iQ%3D%3D> >>> >>> aaeon part no. EP-CBUSB10PFL01 >>> >>> The wiring and the dediprog cable were posted up on tianocore.org under >>> training a long time ago. >>> [image: dediprog14pintoAaeonflashcable.png] >>> >>> >>> I made a cable from a posting from the up-shop community which showed >>> the 12 pin spi connector next to the rtc battery cable (CN16 on my up >>> extreme board). >>> >>> I still do occasional trainings for universities and other customers >>> after I had retired from Intel using the Whiskeylake EDK2-platforms mintree >>> build. >>> There were some other fixes to the code for the memory init that I >>> should go find and post. >>> >>> Harry Hsiung >>> Olympic View Software LLC >>> [email protected] >>> [email protected] >>> >>> >>> >>> On Fri, Nov 14, 2025 at 7:57 PM Rebecca Cran via groups.io <rebecca= >>> [email protected]> wrote: >>> >>>> Last year I bought an UP Xtreme i14 Series with Intel® Core™ Ultra 7 >>>> processor 155H with the hope of enabling EDK2 on it. However the >>>> documentation for the hardware seems very sparse, and it seems the USB/UART >>>> connector cable has been discontinued. >>>> >>>> I was wondering if anyone else has one, or has information about it >>>> which would allow me to get set up to develop and debug firmware for it? >>>> >>>> I’m at the point where I’m ready to rehome it, since without the cable >>>> or hardware information it’s no use to me. >>>> >>>> — >>>> Rebecca Cran >>>> >>>> >>>> >>>> >>>> >>>> -=-=-=-=-=-=-=-=-=-=-=- Groups.io Links: You receive all messages sent to this group. View/Reply Online (#121679): https://edk2.groups.io/g/devel/message/121679 Mute This Topic: https://groups.io/mt/116303542/21656 Group Owner: [email protected] Unsubscribe: https://edk2.groups.io/g/devel/unsub [[email protected]] -=-=-=-=-=-=-=-=-=-=-=-
