On 8/8/06, Christopher Blizzard <[EMAIL PROTECTED]> wrote:
Anderson Briglia wrote:
> I just followed the instructions available at
> (http://wiki.laptop.org/go/Installing_Fedora_Core#Getting_Ready_to_Install)
> to install the Fedora Core into an OLPC board (PCB A) but the
> installation stops at "An error has occurred - no valid devices were
> found ..." error. Anybody can tell me what I'm doing wrong?
>
At what point did you see that error? In the installer? Or once you
did the install and tried to reboot?
If it was during the installer that usually means that it couldn't find
USB install media that you wanted to install on.
It was in the installer but I already found the solution. I read again
the wiki page (after send this email to the list) that I mentioned
before and there is an USB hub issue reported there. I just
disconnect/connect the USB hub after the boot process and everything
worked.
Thanks.
Anderson Briglia
_______________________________________________
Devel mailing list
[email protected]
http://mailman.laptop.org/mailman/listinfo/devel
