We probably don't care, so long as we've been able to do a verify pass
on the firmware and confirmed the bits loaded were as intended; if not,
we want to stop and let us try to figure out went wrong...
- Jim
On Wed, 2006-08-16 at 11:33 -0500, Richard Smith wrote:
> - Pulling KBC out of reset after SPI programming causes a reboot. Do we care?
>
> I'm sending off a question to the EnE FAE about the cause of this.
>
> I suspect this is a feature rather than a bug. When the EC code
> starts running I bet it goes off and does its normal boot sequence
> which probably involves playing with the reset and power signals up to
> the GX2.
>
--
Jim Gettys
One Laptop Per Child
_______________________________________________
Devel mailing list
[email protected]
http://mailman.laptop.org/mailman/listinfo/devel
