Some defines are no longer referenced in the code, so removed them.

Signed-off-by: Mark Einon <[email protected]>
---
 drivers/staging/et131x/et131x.c |   11 -----------
 1 files changed, 0 insertions(+), 11 deletions(-)

diff --git a/drivers/staging/et131x/et131x.c b/drivers/staging/et131x/et131x.c
index 1c11dfd..1efa27c 100644
--- a/drivers/staging/et131x/et131x.c
+++ b/drivers/staging/et131x/et131x.c
@@ -145,21 +145,14 @@ MODULE_DESCRIPTION("10/100/1000 Base-T Ethernet Driver "
 /* MP_ADAPTER flags */
 #define fMP_ADAPTER_RECV_LOOKASIDE     0x00000004
 #define fMP_ADAPTER_INTERRUPT_IN_USE   0x00000008
-#define fMP_ADAPTER_SECONDARY          0x00000010
 
 /* MP_SHARED flags */
-#define fMP_ADAPTER_SHUTDOWN           0x00100000
 #define fMP_ADAPTER_LOWER_POWER                0x00200000
 
 #define fMP_ADAPTER_NON_RECOVER_ERROR  0x00800000
-#define fMP_ADAPTER_RESET_IN_PROGRESS  0x01000000
-#define fMP_ADAPTER_NO_CABLE           0x02000000
 #define fMP_ADAPTER_HARDWARE_ERROR     0x04000000
-#define fMP_ADAPTER_REMOVE_IN_PROGRESS 0x08000000
-#define fMP_ADAPTER_HALT_IN_PROGRESS   0x10000000
 
 #define fMP_ADAPTER_FAIL_SEND_MASK     0x3ff00000
-#define fMP_ADAPTER_NOT_READY_MASK     0x3ff00000
 
 /* Some offsets in PCI config space that are actually used. */
 #define ET1310_PCI_MAX_PYLD            0x4C
@@ -205,7 +198,6 @@ MODULE_DESCRIPTION("10/100/1000 Base-T Ethernet Driver "
 
 #define NUM_PACKETS_HANDLED    256
 
-#define ALCATEL_BAD_STATUS     0xe47f0000
 #define ALCATEL_MULTICAST_PKT  0x01000000
 #define ALCATEL_BROADCAST_PKT  0x02000000
 
@@ -452,8 +444,6 @@ struct tx_ring {
  * Once the desired performance has been achieved, the optimal registry values
  * should be re-populated to these #defines:
  */
-#define NUM_TRAFFIC_CLASSES          1
-
 #define TX_ERROR_PERIOD             1000
 
 #define LO_MARK_PERCENT_FOR_PSR     15
@@ -4715,7 +4705,6 @@ void et131x_disable_interrupts(struct et131x_adapter 
*adapter)
        writel(INT_MASK_DISABLE, &adapter->regs->global.int_mask);
 }
 
-
 /**
  * et131x_isr - The Interrupt Service Routine for the driver.
  * @irq: the IRQ on which the interrupt was received.
-- 
1.7.6.4

_______________________________________________
devel mailing list
[email protected]
http://driverdev.linuxdriverproject.org/mailman/listinfo/devel

Reply via email to