These two places seem like they should be using bitwise OR instead of
bitwise AND. The first one is a noop which is equivalent to:
imr |= (0x0100 & 0x0004 & 0x0001);
The second is sets lcr2 to zero instead of just clearing the high bits.
lcr2 &= (0x00F0 & 0x000F);
Signed-off-by: Dan Carpenter <[email protected]>
---
I don't have this hardware.
diff --git a/drivers/staging/et131x/et131x.c b/drivers/staging/et131x/et131x.c
index 5b11c5e..0582183 100644
--- a/drivers/staging/et131x/et131x.c
+++ b/drivers/staging/et131x/et131x.c
@@ -1767,8 +1767,8 @@ static void et131x_xcvr_init(struct et131x_adapter
*adapter)
/* Set the link status interrupt only. Bad behavior when link status
* and auto neg are set, we run into a nested interrupt problem
*/
- imr |= (ET_PHY_INT_MASK_AUTONEGSTAT &
- ET_PHY_INT_MASK_LINKSTAT &
+ imr |= (ET_PHY_INT_MASK_AUTONEGSTAT |
+ ET_PHY_INT_MASK_LINKSTAT |
ET_PHY_INT_MASK_ENABLE);
et131x_mii_write(adapter, PHY_INTERRUPT_MASK, imr);
@@ -1784,7 +1784,7 @@ static void et131x_xcvr_init(struct et131x_adapter
*adapter)
if ((adapter->eeprom_data[1] & 0x4) == 0) {
et131x_mii_read(adapter, PHY_LED_2, &lcr2);
- lcr2 &= (ET_LED2_LED_100TX & ET_LED2_LED_1000T);
+ lcr2 &= (ET_LED2_LED_100TX | ET_LED2_LED_1000T);
lcr2 |= (LED_VAL_LINKON_ACTIVE << LED_LINK_SHIFT);
if ((adapter->eeprom_data[1] & 0x8) == 0)
_______________________________________________
devel mailing list
[email protected]
http://driverdev.linuxdriverproject.org/mailman/listinfo/devel
