Use the dev_printk() routines to output the kernel messages in the attach routine.
The main 'attach' message had a level of KERN_ERR, I believe it should have been KERN_INFO. Also, move that message to the end of the attach so it only gets displayed if the attach is successful. Signed-off-by: H Hartley Sweeten <[email protected]> Cc: Ian Abbott <[email protected]> Cc: Frank Mori Hess <[email protected]> Cc: Greg Kroah-hartman <[email protected]> --- drivers/staging/comedi/drivers/ni_daq_700.c | 10 ++++++---- 1 file changed, 6 insertions(+), 4 deletions(-) diff --git a/drivers/staging/comedi/drivers/ni_daq_700.c b/drivers/staging/comedi/drivers/ni_daq_700.c index 94cb346..50fad12 100644 --- a/drivers/staging/comedi/drivers/ni_daq_700.c +++ b/drivers/staging/comedi/drivers/ni_daq_700.c @@ -113,11 +113,8 @@ static int dio700_attach(struct comedi_device *dev, struct comedi_devconfig *it) return -EIO; iobase = link->resource[0]->start; - printk(KERN_ERR "comedi%d: ni_daq_700: %s, io 0x%lx\n", dev->minor, - thisboard->name, iobase); - if (iobase == 0) { - printk(KERN_ERR "io base address is zero!\n"); + dev_err(dev->class_dev, "io base address is zero!\n"); return -EINVAL; } @@ -142,6 +139,11 @@ static int dio700_attach(struct comedi_device *dev, struct comedi_devconfig *it) s->state = 0; s->io_bits = 0x00ff; + dev_info(dev->class_dev, "%s: %s, io 0x%lx\n", + dev->driver->driver_name, + dev->board_name, + dev->iobase); + return 0; }; -- 1.7.11 _______________________________________________ devel mailing list [email protected] http://driverdev.linuxdriverproject.org/mailman/listinfo/devel
