Hi all, after reading
http://www.whyxo.com/2008/01/08/external-monitor-or-projector-for-the-xo/

I am sure, that it is possible to integrate a VGA external connector for the 
OLPC. On the Prototype-A motherboard layout there was such an external VGA 
connector, but on G1G1 version it is gone.
I am a teacher and it would be very good for projection with a beamer or if 
your LCD is broken, to have such an external VGA connector. 
My problem is, that I have no schematic or a good photo of both sides of the 
Prototype-A motherboard. You can read in the Geode LX databook, that the Geode 
LX chip offers direct VGA support and connection. But some parts of the 
Prototype-A motherboard have gone in G1G1 version and so I cannot see, which 
direct lines from the processor has to be used for the direct VGA support. Pin 
1,2,3 are used for the RGB signal on the G1G1 layout, and pin 13 seems to be 
Hsync and pin 14 Vsync. I do not know, what is the use of pin 4,9,12,15, 
because they are also wired on the G1G1 version.
Pin 5, 6,7,8,10,11 are not connected on the G1G1 version and I think, that this 
was the same for the Prototype-A motherboard layout. But still there must be 
the lines direct to the Geode processor from the Prototype-A layout. They only 
have to be found (recogniced) via a good photo of the Prototype-A layout (both 
sides). Please send me your photos and rtell me, what you think about my idea,

Dietmar

PS: RGB lines of VGA ends on G1G1 layout direct in front of C51, C41, C86. If 
this is true, only Vsync and Hsync have to be found.

Wikipedia says about the pins for VGA:

Pin 1 RED Red video 
Pin 2 GREEN Green video 
Pin 3 BLUE Blue video 
Pin 4 N/C Not connected 
Pin 5 GND Ground (HSync) 
Pin 6 RED_RTN Red return 
Pin 7 GREEN_RTN Green return 
Pin 8 BLUE_RTN Blue return 
Pin 9 +5 V +5 V (DDC) 
Pin 10 GND Ground (VSync, DDC) 
Pin 11 N/C Not connected 
Pin 12 SDA I²C data 
Pin 13 HSync Horizontal sync 
Pin 14 VSync Vertical sync 
Pin 15 SCL I²C clock 
_______________________________________________
Devel mailing list
[email protected]
http://lists.laptop.org/listinfo/devel

Reply via email to