greebo wrote: > >> To determine if it is a battery problem follow the instructions for >> using opc-pwr-log. (This should be pre-installed on 757). >> The instructions are at: >> >> http://wiki.laptop.org/go/XO_LiFePO4_Recovery_Procedure > > Will do and will post results.
You may want to modify this script a bit. The delay method I uses the clock and a sleep 2 loop rather than just a sleep x command for the delay. The reason is so I can delay properly across an idle-suspend. The sleep(2) loop may not be the best for this sort of measurement. Each reading involved lots of EC commands. Its probably a good idea to replace the 'wallclock_delay' with 'sleep'. Idle-suspend is off in those builds so the wallclock feature is not needed. By default DELAY is set to 10 seconds but if you really wanted a sense of the idle power you can increase that to 60 or even longer. The ACR reading will track the over all power used accurately regardless of the delay time. Smaller delays are good if you want to try and catch some peaks. -- Richard Smith <[EMAIL PROTECTED]> One Laptop Per Child _______________________________________________ Devel mailing list Devel@lists.laptop.org http://lists.laptop.org/listinfo/devel
