Hi,
> This time at WeyJia it was their FUJI XP-243E ? > http://en.qi-hardware.com/wiki/File:WeyJia_fuji_xp243e.jpg > > Yes, this one. > How many mm is the conveyor blocking? What are the fiducial mark > requirements? > > Its conveyor blocks 3 mm. So either put the fiducial mark (its inner circle ring ) away from board's outter edge then will be fine. In the past, I used 8mm or 10mm for width of board strips and put mark at center coordinates. See http://www.smtnet.com/index.cfm?fuseaction=search_submit&collection=site_forum&searchstring=fiducial%20mark This site introduces a lot of info. If possible, just put the mark within single board design will always good or just adding bigger width to 10mm. Then this panel gerber you probably can bring it to most of smt machine to mount it. But it depends. :) At the smt machine, its software is more elasticity than we thought. Just case by case. Adam
_______________________________________________ http://lists.milkymist.org/listinfo.cgi/devel-milkymist.org IRC: #milkym...@freenode Twitter: www.twitter.com/milkymistvj Ideas? http://milkymist.uservoice.com
