Hi Javier,

As far as the kernel, configurations and environment, we conducted the tests
with the same setup.  We follow exactly like what is mentioned in the
HOWTO.  Eventhough the environment is not 'quiet', we did our test by using
conducted testing.

Open MESH results are okay (the Rx Signal Strength is about -10 dBm
consistently).

For SAE, we noticed that the Rx signal strength fluctuated, from 2dBm until
-70dBm.  It's a huge fluctuation there.  It was observed on all WLAN cards
that we used (all based on Atheros chipset).  That resulted into the bitrate
seen fluctuated as well, at times didn't make it to the endpoint.

So, we are wondering what would make the fluctuation to happen.  Is it
something to do with the wpa_supplicant <-> driver relationship or anything
else that could be the real disturbance?.  Appreciate your input.
Thanks.

Rgds,
Zaki.






On Thu, Apr 14, 2011 at 12:06 PM, Javier Cardona <jav...@cozybit.com> wrote:

> Hi Zaki,
>
> On Tue, Apr 12, 2011 at 11:29 PM, Zaki <zaki...@gmail.com> wrote:
> > We are actively doing testings with Open and SAE Mesh.  While Open Mesh's
> > throughput looks fine, SAE's throughput looks a bit strange.  Please
> refer
> > to here http://www.ahmadzaki.com/?p=16 to see the block diagram of the
> setup
> > we are using and the detail results out of them.  Anybody know if the
> > results are normal?.
>
> SAE is only used for authentication.  Once a station is authenticated,
> everything should behave exactly the same as an open mesh, so there
> should be no effect on throughput (this may change once AMPE and
> encryption are released).   I would suspect on other factors, for
> instance configuration, kernel or changes to your wireless environment
> (are you running your tests in a controlled environment?).    To be
> absolutely sure, you could repeat your SAE throughput measurements
> with the same kernel and configuration but over unauthenticated peer
> links.  The HOWTO explains how to create unauthenticated peer links
> (http://o11s.org/trac/wiki/HOWTO#openmesh).  Throughput numbers should
> be identical.
>
> Cheers,
>
> Javier
>
> --
> Javier Cardona
> cozybit Inc.
> http://www.cozybit.com
>
_______________________________________________
Devel mailing list
Devel@lists.open80211s.org
http://open80211s.com/mailman/listinfo/devel

Reply via email to