Hi, 2011-10-20 03:03, wrote Thomas Pedersen: > Include the WMM IE in mesh peering and beacon frames. This is needed > tell any potential peers what our WMM / EDCA parameters are.
IEEE 802.11s-2011 states that mesh STAs use the default EDCA parameter set only. Clause 9.1.3.1 in 802.11s-2011 reads: "When communicating within a BSS, the EDCA parameters used are […] from the default values for the parameters […] when the STA is a mesh STA." Thus, all mesh STAs use the same (default) EDCA parameter set. Since the standard does not allow mesh STAs to change their EDCA parameters, there is no need to signal the current settings. Thus, the EDCA parameter set is not included with management frames sent by mesh STAs. Table 7-8 (Beacon frame body) and Table 7-15 (Probe Response frame body) state that "The EDCA Parameter Set element is present if dot11QosOptionImplemented is true, and dot11MeshActivated is false […]." So, there is no need to signal any EDCA parameter set within an MBSS. Best regards, Guido _______________________________________________ Devel mailing list [email protected] http://open80211s.com/mailman/listinfo/devel
