Hi Guys, I'm working on setting up a mesh network with multiple unmanned aerial vehicles. I'm working on Ubiquiti bullet 5 Ghz module. The hardware is AR2313 with ath5k driver. I'm currently doing testing with just two nodes (one is plane and one is ground station) being setup with . The problem I've noticed today is as follows: If A (ground station) and B (plane) are communicating and suddenly B goes out of range. Though, B comes back immediately in the range. Both nodes can't communicate to each other for at least a minute. The traffic is all UDP traffic. I had this problem in the lab environment too. I could only get the connection back by restarting the node B in lab environment. In the tests that involved using proprietary firmware of Ubiquiti in access point and station mode, there was no such delay in the link recovery after failure at all. Any comments on this problem will be appreciated.
Regards, Siva. _______________________________________________ Devel mailing list [email protected] http://lists.open80211s.org/cgi-bin/mailman/listinfo/devel
