Hi, the instruction on the wiki are good and i have followed this up to the fact that i use a minimal Debian (so i can say there was no access to the GSM Modem) instead of the fso-console image.
The firmware update has startet after i do "s3c24xx-gpio b7=1", however the update process was interrupted, first on this point i had a problem than any try to update hangs on the Bootloader: (reset target) the "s3c24xx-gpio b7=1" had no effect. A few "echo 0 >power_on" "echo 1 >power_on" instead of "s3c24xx-gpio b7=1" had done the trick and i am not sure if the FLUID_FLOWCONTROL=h needed or not. greets Michael _______________________________________________ devel mailing list [email protected] https://lists.openmoko.org/mailman/listinfo/devel
