Hi at all. I'm working on a free driver for the WLAN-Chip in the G1. But the kernel [1] gives alway an error [2]. Does anyone have an idea how I could get this problem fixed?
greatings leviathan [1] http://pub.o2s.ch/pub/openmoko-msm-2.6.29.tar.bz2 [2] [ 57.266998] cfg80211: Calling CRDA for country: US [ 57.591735] wl12xx: registering driver [ 57.592010] trout_wifi_power: 1 [ 57.796386] trout_wifi_reset: 0 [ 57.847412] trout_wifi_set_carddetect: 1 [ 57.847442] mmc0: card_present 1 [ 57.847473] mmc0: Slot status change detected (0 -> 1) [ 60.360046] mmc0: Command timeout [ 60.366943] mmc0: card claims to support voltages below the defined range. These will be ignored. [ 60.367034] mmc0: SDIO card claims to support the incompletely defined 'low voltage range'. This will be ignored. [ 60.369720] mmc0: new SDIO card at address 0001 [ 60.397216] wl12xx: in probe [ 60.398193] wmaster0 (wl12xx_sdio): not using net_device_ops yet [ 60.399719] phy0: Selected rate control algorithm 'minstrel' [ 60.519439] wlan0 (wl12xx_sdio): not using net_device_ops yet [ 60.523376] wl12xx: loaded [ 60.524566] wl12xx: initialized [ 61.516510] wl12xx_sdio mmc0:0001:1: firmware: requesting wl1251-fw.bin [ 61.673034] wl12xx_sdio mmc0:0001:1: firmware: requesting wl1251-nvs.bin [ 64.372253] ------------[ cut here ]------------ [ 64.372283] WARNING: at kernel/irq/manage.c:222 __enable_irq+0x40/0x70() [ 64.372314] Unbalanced enable for IRQ 0 [ 64.372344] Modules linked in: wl12xx_sdio wl12xx mac80211 cfg80211 ipv6 [ 64.372406] [<c0028714>] (dump_stack+0x0/0x14) from [<c004d880>] (warn_slowpath+0x70/0x8c) [ 64.372467] [<c004d810>] (warn_slowpath+0x0/0x8c) from [<c0079e30>] (__enable_irq+0x40/0x70) [ 64.372528] r3:00000000 r2:c02eb3e0 [ 64.372558] r7:c63527c8 r6:c6352cdc r5:00000000 r4:c0336f8c [ 64.372589] [<c0079df0>] (__enable_irq+0x0/0x70) from [<c007a21c>] (enable_irq+0x40/0x6c) [ 64.372650] r4:a0000013 [ 64.372680] [<c007a1dc>] (enable_irq+0x0/0x6c) from [<bf0819a8>] (wl12xx_boot_run_firmware+0xf0/0x16c [wl12xx]) [ 64.372894] r5:00000070 r4:c6352cc0 [ 64.372924] [<bf0818b8>] (wl12xx_boot_run_firmware+0x0/0x16c [wl12xx]) from [<bf0825ac>] (wl1251_boot+0xd4/0x108 [wl12xx]) [ 64.373138] r5:00000000 r4:c6352cc0 [ 64.373168] [<bf0824d8>] (wl1251_boot+0x0/0x108 [wl12xx]) from [<bf07f084>] (wl12xx_op_start+0x58/0xbc [wl12xx]) [ 64.373352] r5:00000000 r4:c6352cc0 [ 64.373382] [<bf07f02c>] (wl12xx_op_start+0x0/0xbc [wl12xx]) from [<bf063d78>] (ieee80211_open+0x30c/0x7c0 [mac80211]) [ 64.373718] r6:c6349360 r5:c6352180 r4:c6349000 [ 64.373779] [<bf063a6c>] (ieee80211_open+0x0/0x7c0 [mac80211]) from [<c01f0dac>] (dev_open+0x9c/0xfc) [ 64.373992] [<c01f0d10>] (dev_open+0x0/0xfc) from [<c01efac0>] (dev_change_flags+0x98/0x170) [ 64.374053] r5:00000041 r4:c6349000 [ 64.374084] [<c01efa28>] (dev_change_flags+0x0/0x170) from [<c0233d80>] (devinet_ioctl+0x370/0x798) [ 64.374145] r7:00000001 r6:c6345e78 r5:00000000 r4:00008914 [ 64.374176] [<c0233a10>] (devinet_ioctl+0x0/0x798) from [<c0234da4>] (inet_ioctl+0xd0/0xfc) [ 64.374237] [<c0234cd4>] (inet_ioctl+0x0/0xfc) from [<c01e1974>] (sock_ioctl+0x1f4/0x250) [ 64.374328] [<c01e1780>] (sock_ioctl+0x0/0x250) from [<c00b4650>] (vfs_ioctl+0x38/0x98) [ 64.374389] r7:00000036 r6:be9f2ae0 r5:00008914 r4:c61f1e60 [ 64.374420] [<c00b4618>] (vfs_ioctl+0x0/0x98) from [<c00b4ca0>] (do_vfs_ioctl+0x4f8/0x56c) [ 64.374481] r6:be9f2ae0 r5:00000003 r4:c61f1e60 [ 64.374511] [<c00b47a8>] (do_vfs_ioctl+0x0/0x56c) from [<c00b4d54>] (sys_ioctl+0x40/0x64) [ 64.374572] r9:c6344000 r8:c0024f24 r6:00008914 r5:fffffff7 r4:c61f1e60 [ 64.374633] [<c00b4d14>] (sys_ioctl+0x0/0x64) from [<c0024da0>] (ret_fast_syscall+0x0/0x2c) [ 64.374694] r6:be9f2f62 r5:00001043 r4:00086960 [ 64.374755] ---[ end trace 781e56170b9d3a72 ]--- [ 64.546203] wl12xx: 151 tx blocks at 0x3b788, 35 rx blocks at 0x3a780 [ 64.546691] wl12xx: firmware booted (Rev 4.0.4.3.5) [ 64.565521] ADDRCONF(NETDEV_UP): wlan0: link is not ready
signature.asc
Description: This is a digitally signed message part.
_______________________________________________ devel mailing list devel@lists.openmoko.org https://lists.openmoko.org/mailman/listinfo/devel