Hal Murray via devel writes: > You can build your own with PPS by adding a few wires to the combination of a > GPS breakout board and a USB-serial with breakout on the serial side. There > is at least one USB-serial chip available on a breakout that polls at 1/4 ms. > I'll look up part numbers that I'm using if anybody is interested.
Thanks, but I already have plenty of those. For a moment I was hoping that the NaviSys USB stick and puck I bought earlier would be able to send PPS over USB, but that's not the case (they are both using the built-in USB interface that uBlox provides). The puck does have a PPS output that I need to break out (PPS is not officially supported in that model so the driver circuit is missing, but that gives me a convenient location to solder the wire to). The stick has no convenient way to open the case, so I'll probably leave it alone. Regards, Achim. -- +<[Q+ Matrix-12 WAVE#46+305 Neuron microQkb Andromeda XTk Blofeld]>+ SD adaptations for Waldorf Q V3.00R3 and Q+ V3.54R2: http://Synth.Stromeko.net/Downloads.html#WaldorfSDada _______________________________________________ devel mailing list devel@ntpsec.org http://lists.ntpsec.org/mailman/listinfo/devel