Applying with these fixes on my side: - paragraphs 1 and 2 of the commit message replaced with:
A flip_upper_deltas after a grow of the device, with the lower delta left at its old size, makes a top delta whose header covers fewer entries than the delta below it. Unless a write rewrites BAT page 0 first, the stack no longer loads. When the grow added BAT clusters, a write past the old size can also put a BAT page onto a data cluster of that file. Today ploop_check_delta_before_flip() oopses on such a flip only when the grow added BAT pages, as its walk runs past the end of the BAT of the lower delta. A grow within the same BAT pages already gets through, and fixing the walk alone would let every such flip through. - paragraph 3: "Read the header of the lower delta on every flip, not only under PLOOP_DEBUG" became "Check the size of the lower delta outside PLOOP_DEBUG", and "a stack that ploop_add_delta() refuses on the next load" became "a top delta whose header covers fewer entries than the delta below it". On Thu, 05 Nov 2026 15:57:48 +0100, Denis V. Lunev wrote: > A flip_upper_deltas after a grow of the device, with the lower delta > left at its old size, makes a top delta whose header and BAT cover fewer > entries than the device. After resume the BAT writeback puts the grown > header into page 0 of that file and the BAT pages past its old size onto > its data clusters, and the image no longer opens. Only dirty BAT pages are written back, and page 0 gets dirty only from a write to its own clusters. BAT pages land on data only when the grow added BAT clusters. In your 1G -> 2G test the new top kept its old m_Size, and that is the EPROTO you saw. My v1 reply described it wrongly. > Today ploop_check_delta_before_flip() oopses on such a flip before it > gets that far, as its walk runs past the end of the BAT of the lower > delta. Fixing the walk alone would let the flip through. The old walk oopses only when the grow added BAT pages; a grow within the same pages returns 0 and the flip goes through today. > Read the header of the lower delta on every flip, not only under > PLOOP_DEBUG, and refuse with -EBADSLT when it has fewer BAT entries than The call reads and converts the whole BAT, as Sashiko said, and it already ran on every flip since PLOOP_DEBUG is always defined. Whether the flipped stack fails with EPROTO or EBADSLT depends on how the table length is set, so the new text names no errno. With that fixed: Reviewed-by: Konstantin Khorenko <[email protected]> -- Konstantin Khorenko, Virtuozzo Linux Kernel Team _______________________________________________ Devel mailing list [email protected] https://lists.openvz.org/mailman/listinfo/devel
