Added instructions to run examples on raspberrypi. --- user/bsps/arm/raspberrypi.rst | 74 ++++++++++++++++++++++++++++++++++- 1 file changed, 73 insertions(+), 1 deletion(-)
diff --git a/user/bsps/arm/raspberrypi.rst b/user/bsps/arm/raspberrypi.rst index 4ef75bd..7eccca5 100644 --- a/user/bsps/arm/raspberrypi.rst +++ b/user/bsps/arm/raspberrypi.rst @@ -5,4 +5,76 @@ raspberrypi =========== -TODO. +This BSP supports `Raspberry Pi 1` and `Raspberry Pi 2` currently. +The support for `Raspberry Pi 3` is work under progress. +The default bootloader on the raspberrypi which is used to boot raspbian +or other OS can be also used to boot RTEMS. U-boot can also be used. + +Setup SD card +---------------- + +The Raspberry Pis have an unconventional booting mechanism. The GPU +boots first, initializes itself, runs the bootloader and starts the CPU. +The bootloader looks for a kernel image, by default the kernel images must +have a name of the form `kernel*.img` but this can be changed by adding +`kernel=<img_name>` to config.txt. + +You must provide the required files for the GPU to proceed. These files +can be downloaded from this +`link <https://github.com/raspberrypi/firmware/tree/master/boot>`_. +You can remove the kernel*.img if you want, but don't touch the other files. + +Copy these files in to a SD card with FAT filesystem. + +Kernel image +------------ + +The following steps show how to run hello.exe on a Raspberry Pi 2. +The same instructions can be applied to Raspberry Pi 1 also. +Other executables can be processed in a similar way. + +To create the kernel image: + +.. code-block:: none + + arm-rtems5-objcopy -Obinary hello.exe kernel.img + +Copy the kernel image to the SD card. + +Make sure you have these lines below in your config.txt. + +.. code-block:: none + + enable-uart=1 + kernel_address=0x200000 + kernel=kernel.img + +Testing +------- + +Qemu along with GDB can be used for debugging, but it only supports +``Raspberry Pi 2`` and the emulation is also incomplete. So some of the +features might not work as expected. + +Make sure you have latest version of qemu, because older ones don't support +Raspberry Pi. + +.. code-block:: none + + qemu-system-arm -M raspi2 -m 1G -kernel hello.exe -serial mon:stdio -nographic -S -s + +This starts qemu and creates a socket at port ``localhost:1234`` for GDB to +connect. + +In a new terminal, run GDB using + +.. code-block:: none + + arm-rtems5-gdb hello.exe + tar remote:1234 + load + +This will connect GDB to qemu and load the application. + +**Note**: Add ``set scheduler-locking on`` in GDB if you have any issues +running the examples. \ No newline at end of file -- 2.17.1 _______________________________________________ devel mailing list devel@rtems.org http://lists.rtems.org/mailman/listinfo/devel