Hi Ivan,

I'm reaching out because I'm having trouble communicating with the Odroid-C4 
via UART.

I successfully flashed your image and can see the message "Hit any key to stop 
autoboot: 0", but when using Minicom or Picocom at a baud rate of 115200, I'm 
unable to send any data. Additionally, when I try to listen to the boot output, 
all the data appears corrupted and unreadable. I'm connected to the UART 
interface, not through the GPIO.

For comparison, I was able to successfully boot the official Odroid-C4 Ubuntu 
image without any issues.

Is there anything I might be doing wrong? Could the baud rate be different from 
115200?

Thanks again for your help!

Best regards,
Julia
_______________________________________________
Devel mailing list -- devel@sel4.systems
To unsubscribe send an email to devel-leave@sel4.systems

Reply via email to