|
hi i am writing a new driver for
xfree86
A long time ago i registered is an xf-developer
working on an S3 driver but the
S3 driver did not go any ware and it is now
closed but i think i am stall registered
for that project so can someone help me close the
S3 project and open my new one ?
my new driver is called NVXF for (NVIDIA
xfree86)
i no there is all ready a NV driver for xfree but
this driver is so different
it supports full hardware accel 2D / 3D 32 bpp on
(NV04 , NV05) chips (NV1x - NV2x) soon
it uses DMA for 2D / 3D commands and most image
transfers
the driver is about 80% written for 3.3.6 i want to
parallel build the 4.x.x driver
at the same time as the 3.3.6 as the HW cores are
the same
can i have the GLX 3D part in the driver itself for
3.3.6 and 4.x.x ?
i have some problems
to start quickly i just roat over the I128 driver
in xc/programs/Xserver/hw/xfree86/accel/i128
so i need help on how to properly link my driver in
if possible i wold like the dir
xc/programs/Xserver/hw/xfree86/accel/nvxf for 3.3.6
and xc/programs/Xserver/hw/xfree86/drivers/nvxf for
4.x.x
can some one help me on where to put the reference
to my driver in the Makefile
and the like
also can i set up a developer mail list for this
driver ?
DAVID RUNDLE [EMAIL PROTECTED]
thank you
|
