On Mon, Feb 14, 2005 at 07:40:40PM -0800, Mark Vojkovich wrote: >On Mon, 14 Feb 2005, Mark Vojkovich wrote: > >> On Mon, 14 Feb 2005, David Dawes wrote: >> >> > On Mon, Feb 14, 2005 at 04:00:18PM -0800, Mark Vojkovich wrote: >> > > I just updated on my dual-card system and with the update I see >> > >a problem restoring the console that I did not see previously. If >> > >I startx on the primary card and then quit, the primary card is restored >> > >correctly. However, if I startx on both cards and quit, the >> > >primary card is not restored correctly. I have a hard time imagining >> > >how it could be a driver issue since the "nv" driver knows nothing about >> > >the other cards in the layout (nor should it) and does not change >> > >its behavior when there is more than one card in the layout. The >> > >core server code, on the other hand, does. >> > > >> > > Have there been changes to vgahw, RAC, PCI config code, console >> > >code, etc... that may have caused this regression? >> > >> > Do you know approximately when this problem started? >> >> I haven't updated in a long time on that machine. I'll try to >> figure out when, but I'm not sure how to do that reliably. > > I can't tell when I last updated on this machine.
Can you go back to 4.4 as a first step, or do you know it was post-4.4? I tried 4.5.0 RC1 with a multi-head config using a Mach64 and i810, and didn't see any problem like this. I can try some other multi-head configs later this week. David _______________________________________________ Devel mailing list Devel@XFree86.Org http://XFree86.Org/mailman/listinfo/devel