I tested 'cli.bat' again, and I could see the username prompt after about
20 seconds.
I also tested sample client programs and these showed the similar results.
(I ran the server and client on windows 2000 machines.)
Thanks in advance,
----- Original Message -----
From: "Andreas Mueller" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Thursday, January 04, 2001 10:14 PM
Subject: [developers] Connection is too slow...
>
> Jung-Ho Ahn wrote:
> >
> > I've just installed swiftmq 1.2c and tried cli.bat and explorer.bat.
> > These worked well, but the first connection time is too slow -- a few
> > seconds long.
> > The server and client machines are connected via LAN and I don't think
> > there was any network congestion...
>
> The explorer needs a few seconds to connect (until you see the routers
> in the navigator), because it receives the management trees of all
> routers. But cli should be faster. I see the username prompt here under
> 1 sec.
>
> --
> Andreas Mueller, [EMAIL PROTECTED], IIT GmbH, Bremen/Germany, http://www.iit.de
> SwiftMQ - JMS Enterprise Messaging System, http://www.swiftmq.com
>
> ------------------------------------------------------
> SwiftMQ developers mailing list * http://www.swiftmq.com
> To unsubscribe from this list, send an eMail to
> [EMAIL PROTECTED] and write in the body of your message:
> UNSUBSCRIBE developers <your-email-address>
> Archive: http://www.mail-archive.com/developers@mail.iit.de/
>
>
>
------------------------------------------------------
SwiftMQ developers mailing list * http://www.swiftmq.com
To unsubscribe from this list, send an eMail to
[EMAIL PROTECTED] and write in the body of your message:
UNSUBSCRIBE developers <your-email-address>
Archive: http://www.mail-archive.com/developers@mail.iit.de/
