Hi,
this may be because the fields are not wide enough for the datatypes you try to put there - then the fields use multiple lines, and the fields below are moved further down.
Try making the fields wider.
Regards
Palle M�lgaard
________________________________
From: [email protected] [mailto:[EMAIL PROTECTED] On Behalf Of pbercher
Sent: 20. april 2005 13:40
To: [email protected]
Subject: [development-axapta] report layout Ax 2.5 / SP2
Hi,
i have a funy problem with the report design in Ax. 2.5 /Sp2
I set in a report section 3 values in 3 different lines
(Value 1: Top = 0 Char, Value 2: Top =1 Char, Value 3: Top = 3 char)
The preview / grafical design shows me everything fine.. but when
printing (running the report) the vaules are placed on completely
different lines / prositions..
Any suggestions?
Pirmin
PS: also did postion by cm/mm instead of char > same result !
________________________________
Yahoo! Groups Links
* To visit your group on the web, go to:
http://groups.yahoo.com/group/development-axapta/
* To unsubscribe from this group, send an email to:
[EMAIL PROTECTED] <mailto:[EMAIL PROTECTED]>
* Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service <http://docs.yahoo.com/info/terms/> .
[Non-text portions of this message have been removed]
Yahoo! Groups Links
- To visit your group on the web, go to:
http://groups.yahoo.com/group/development-axapta/
- To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
- Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
