On 2/22/2012 3:23 PM, Rob Herring wrote:
On 02/15/2012 10:04 AM, Benoit Cousson wrote:
Adapt the GPIO driver to retrieve information from a DT file.
Allocate the irq_base dynamically and rename bank->virtual_irq_start
to bank->irq_base.
Change irq_base type to int instead of u16 to match irq_alloc_descs
output.
Add documentation for GPIO properties specific to OMAP.
Signed-off-by: Benoit Cousson<[email protected]>
Cc: Tarun Kanti DebBarma<[email protected]>
One comment below, but otherwise:
Acked-by: Rob Herring<[email protected]>
---
.../devicetree/bindings/gpio/gpio-omap.txt | 30 +++++
drivers/gpio/gpio-omap.c | 121 ++++++++++++++++++--
2 files changed, 142 insertions(+), 9 deletions(-)
create mode 100644 Documentation/devicetree/bindings/gpio/gpio-omap.txt
diff --git a/Documentation/devicetree/bindings/gpio/gpio-omap.txt
b/Documentation/devicetree/bindings/gpio/gpio-omap.txt
new file mode 100644
index 0000000..c1b3100
--- /dev/null
+++ b/Documentation/devicetree/bindings/gpio/gpio-omap.txt
@@ -0,0 +1,30 @@
+OMAP GPIO controller bindings
+
+Required properties:
+- compatible:
+ - "ti,omap2-gpio" for OMAP2 controllers
+ - "ti,omap3-gpio" for OMAP3 controllers
+ - "ti,omap4-gpio" for OMAP4 controllers
+- #gpio-cells : Should be two.
+ - first cell is the pin number
+ - second cell is used to specify optional parameters (unused)
+- gpio-controller : Marks the device node as a GPIO controller.
+- #interrupt-cells : Should be one
There's no level/edge settings for gpios?
That's a good question, because I was wondering as well :-)
I did no see how it was done in other GPIO implementation.
Benoit
_______________________________________________
devicetree-discuss mailing list
[email protected]
https://lists.ozlabs.org/listinfo/devicetree-discuss
