On Thu, Mar 08, 2012 at 03:51:25PM +0100, Thierry Reding wrote: > +- gpio-controller: mark the device as a GPIO controller > +- regulators: list of regulators provided by this controller, must be in the > + following order: > + SM0, SM1, SM2, LDO0, LDO1, LDO2, LDO3, LDO4, LDO5, LDO6, LDO7, LDO8, LDO9
This ordering requirement is fairly sad, if there are unused regulators
they still need to be listed even though...
> + sm0_reg: sm0 {
> + regulator-min-microvolt = < 725000>;
> + regulator-max-microvolt = <1500000>;
> + regulator-boot-on;
> + regulator-always-on;
> + };
> +
> + sm1_reg: sm1 {
...they all seem to be explicitly named in the device tree so presumably
there's enough information in there for the driver to pick any set of
regulators in any order. This would be much nicer to use.
Otherwise this looks good.
signature.asc
Description: Digital signature
_______________________________________________ devicetree-discuss mailing list [email protected] https://lists.ozlabs.org/listinfo/devicetree-discuss
