On 08/03/2012 02:47 AM, Leela Krishna Amudala wrote: > Hello, > > On Fri, Aug 3, 2012 at 10:58 AM, Stephen Warren <[email protected]> wrote: >> On 08/02/2012 09:39 PM, Leela Krishna Amudala wrote: >>> Hello, >>> >>> Can some one please tell me how to read the args from the gpio handle >>> >>> For example: >>> Consider lcd-reset-gpio = <&gpx0 1 2 3 4>; as my phandle. >>> >>> The 4 args in the above handle denotes >>> >>> <[phandle of the gpio controller node] >>> [pin number within the gpio controller] >>> [mux function] >>> [pull up/down] >>> [drive strength]> >>> >>> My intention is to read the "mux function" and "pull up/down" values >>> from the above handle and do the corresponding operations on that >>> particular gpio. >>> >>> I tried using of_get_named_gpio_flags(struct device_node *np, const >>> char *propname, >>> int index, enum of_gpio_flags *flags); >>> function and I always gets the flags value as '0' irrespective of the >>> values present in phandle of GPIO. ... > I got the required values using of_parse_phandle_with_args() function.
OK, you can certainly do that, but I fully expect pushback on such code if you try and upstream it. Also, it's most likely fragile if your DT property needs to represent a list of GPIOs rather than just 1, given that of_get_named_gpio_flags() doesn't do what you'd expect. _______________________________________________ devicetree-discuss mailing list [email protected] https://lists.ozlabs.org/listinfo/devicetree-discuss
