This patch sets gpio #interrupt-cells from a falsely acquired '1' to '2'
referring to Documentation/devicetree/bindings/gpio/gpio-omap.txt:
The first cell is the GPIO number.
The second cell is used to specify flags:
bits[3:0] trigger type and level flags:
1 = low-to-high edge triggered.
2 = high-to-low edge triggered.
4 = active high level-sensitive.
8 = active low level-sensitive.
But using this trigger cell in a board specific devicetree leads to a
non-starting kernel. This is due to not yet enabled gpio-clocks while
kernel/irq/irqdomain.c tries to set this trigger-flag (from the second
interrupt-cell) to gpio-irq-controller.
Any ideas?
---
arch/arm/boot/dts/omap3.dtsi | 12 ++++++------
1 file changed, 6 insertions(+), 6 deletions(-)
diff --git a/arch/arm/boot/dts/omap3.dtsi b/arch/arm/boot/dts/omap3.dtsi
index 1997b41..e8e6b8f 100644
--- a/arch/arm/boot/dts/omap3.dtsi
+++ b/arch/arm/boot/dts/omap3.dtsi
@@ -99,7 +99,7 @@
gpio-controller;
#gpio-cells = <2>;
interrupt-controller;
- #interrupt-cells = <1>;
+ #interrupt-cells = <2>;
};
gpio2: gpio@49050000 {
@@ -108,7 +108,7 @@
gpio-controller;
#gpio-cells = <2>;
interrupt-controller;
- #interrupt-cells = <1>;
+ #interrupt-cells = <2>;
};
gpio3: gpio@49052000 {
@@ -117,7 +117,7 @@
gpio-controller;
#gpio-cells = <2>;
interrupt-controller;
- #interrupt-cells = <1>;
+ #interrupt-cells = <2>;
};
gpio4: gpio@49054000 {
@@ -126,7 +126,7 @@
gpio-controller;
#gpio-cells = <2>;
interrupt-controller;
- #interrupt-cells = <1>;
+ #interrupt-cells = <2>;
};
gpio5: gpio@49056000 {
@@ -135,7 +135,7 @@
gpio-controller;
#gpio-cells = <2>;
interrupt-controller;
- #interrupt-cells = <1>;
+ #interrupt-cells = <2>;
};
gpio6: gpio@49058000 {
@@ -144,7 +144,7 @@
gpio-controller;
#gpio-cells = <2>;
interrupt-controller;
- #interrupt-cells = <1>;
+ #interrupt-cells = <2>;
};
uart1: serial@4806a000 {
--
1.7.10.4
_______________________________________________
devicetree-discuss mailing list
[email protected]
https://lists.ozlabs.org/listinfo/devicetree-discuss
