PHY reset GPIO handling will be done in the PHY driver
Signed-off-by: Roger Quadros <[email protected]>
Acked-by: Felipe Balbi <[email protected]>
Acked-by: Samuel Ortiz <[email protected]>
---
drivers/mfd/omap-usb-host.c | 28 ----------------------------
1 files changed, 0 insertions(+), 28 deletions(-)
diff --git a/drivers/mfd/omap-usb-host.c b/drivers/mfd/omap-usb-host.c
index eb5db28..138ee98 100644
--- a/drivers/mfd/omap-usb-host.c
+++ b/drivers/mfd/omap-usb-host.c
@@ -430,24 +430,10 @@ static unsigned omap_usbhs_rev2_hostconfig(struct
usbhs_hcd_omap *omap,
static void omap_usbhs_init(struct device *dev)
{
struct usbhs_hcd_omap *omap = dev_get_drvdata(dev);
- struct usbhs_omap_platform_data *pdata = omap->pdata;
unsigned reg;
dev_dbg(dev, "starting TI HSUSB Controller\n");
- if (pdata->phy_reset) {
- if (gpio_is_valid(pdata->reset_gpio_port[0]))
- devm_gpio_request_one(dev, pdata->reset_gpio_port[0],
- GPIOF_OUT_INIT_LOW, "USB1 PHY reset");
-
- if (gpio_is_valid(pdata->reset_gpio_port[1]))
- devm_gpio_request_one(dev, pdata->reset_gpio_port[1],
- GPIOF_OUT_INIT_LOW, "USB2 PHY reset");
-
- /* Hold the PHY in RESET for enough time till DIR is high */
- udelay(10);
- }
-
pm_runtime_get_sync(dev);
reg = usbhs_read(omap->uhh_base, OMAP_UHH_HOSTCONFIG);
@@ -476,20 +462,6 @@ static void omap_usbhs_init(struct device *dev)
dev_dbg(dev, "UHH setup done, uhh_hostconfig=%x\n", reg);
pm_runtime_put_sync(dev);
- if (pdata->phy_reset) {
- /* Hold the PHY in RESET for enough time till
- * PHY is settled and ready
- */
- udelay(10);
-
- if (gpio_is_valid(pdata->reset_gpio_port[0]))
- gpio_set_value_cansleep
- (pdata->reset_gpio_port[0], 1);
-
- if (gpio_is_valid(pdata->reset_gpio_port[1]))
- gpio_set_value_cansleep
- (pdata->reset_gpio_port[1], 1);
- }
}
/**
--
1.7.4.1
_______________________________________________
devicetree-discuss mailing list
[email protected]
https://lists.ozlabs.org/listinfo/devicetree-discuss
