Hello, Following my series for OMAP2+, this series makes use of the C preprocessor when compiling AM3XXX DT files, and accomplishes some improvements to improve overall readability.
The .dtb files were diff-tested before and after applying the series to guarantee identity for all targets. For the am335x boards, I spotted a few output pins with pullup selected, but not enabled. Although it seems a bit strange to me, I left the state untouched. Has someone a rational for this? Is the pullup later activated? Or is it unintentional? This series depends on my previous series "ARM: dts: OMAP2+: Use preprocessor for device trees", itself based on Benoit's for_3.11/dts branch. Regards, Florian Florian Vaussard (4): ARM: dts: AM3XXX: Use #include for all device trees ARM: dts: AM33XX: Use existing constants for GPIOs ARM: dts: AM33XX: Specific pinctrl header ARM: dts: AM33XX: Use pinctrl constants arch/arm/boot/dts/am335x-bone.dts | 28 ++++++++++---------- arch/arm/boot/dts/am335x-evm.dts | 44 +++++++++++++++--------------- arch/arm/boot/dts/am335x-evmsk.dts | 44 +++++++++++++++--------------- arch/arm/boot/dts/am33xx.dtsi | 5 +++- arch/arm/boot/dts/am3517-evm.dts | 2 +- arch/arm/boot/dts/am3517_mt_ventoux.dts | 2 +- include/dt-bindings/pinctrl/am33xx.h | 19 +++++++++++++ 7 files changed, 83 insertions(+), 61 deletions(-) create mode 100644 include/dt-bindings/pinctrl/am33xx.h -- 1.7.5.4 _______________________________________________ devicetree-discuss mailing list [email protected] https://lists.ozlabs.org/listinfo/devicetree-discuss
