We no longer need to model a RESET line as a regulator since
we have the reset-gpio driver available.
Signed-off-by: Roger Quadros <rog...@ti.com>
---
arch/arm/boot/dts/omap4-panda-common.dtsi | 22 ++++++++--------------
1 files changed, 8 insertions(+), 14 deletions(-)
diff --git a/arch/arm/boot/dts/omap4-panda-common.dtsi
b/arch/arm/boot/dts/omap4-panda-common.dtsi
index faa95b5..e9b0a91 100644
--- a/arch/arm/boot/dts/omap4-panda-common.dtsi
+++ b/arch/arm/boot/dts/omap4-panda-common.dtsi
@@ -60,20 +60,13 @@
"AFMR", "Line In";
};
- /*
- * Temp hack: Need to be replaced with the proper gpio-controlled
- * reset driver as soon it will be merged.
- * http://thread.gmane.org/gmane.linux.drivers.devicetree/36830
- */
/* HS USB Port 1 RESET */
- hsusb1_reset: hsusb1_reset_reg {
- compatible = "regulator-fixed";
- regulator-name = "hsusb1_reset";
- regulator-min-microvolt = <3300000>;
- regulator-max-microvolt = <3300000>;
- gpio = <&gpio2 30 0>; /* gpio_62 */
- startup-delay-us = <70000>;
- enable-active-high;
+ hsusb1_reset: hsusb1_reset {
+ compatible = "gpio-reset";
+ reset-gpios = <&gpio2 30 GPIO_ACTIVE_LOW>; /* gpio_62 */
+ reset-delay-us = <70000>;
+ initially-in-reset;
+ #reset-cells = <0>;
};
/* HS USB Port 1 Power */
@@ -97,7 +90,8 @@
/* HS USB Host PHY on PORT 1 */
hsusb1_phy: hsusb1_phy {
compatible = "usb-nop-xceiv";
- reset-supply = <&hsusb1_reset>;
+ resets = <&hsusb1_reset>;
+ reset-names = "reset";
vcc-supply = <&hsusb1_power>;
/**
* FIXME:
--
1.7.4.1
_______________________________________________
devicetree-discuss mailing list
devicetree-discuss@lists.ozlabs.org
https://lists.ozlabs.org/listinfo/devicetree-discuss
