On 13-12-12 12:37 PM, Linus Walleij wrote:
On Wed, Dec 11, 2013 at 7:37 PM, Sherman Yin <[email protected]> wrote:
Adds pinctrl driver devicetree binding for Broadcom Capri (BCM281xx) SoCs.
Signed-off-by: Sherman Yin <[email protected]>
Reviewed-by: Christian Daudt <[email protected]>
Reviewed-by: Matt Porter <[email protected]>
---
v3: Use generic pin config properties instead of brcm-specific ones. Clarified
pin types (standard, i2c, hdmi).
v2: Use hyphens instead of underscore in DT property names.
Overall this is very nice!
Thanks!
+- bias-pull-up: Integer. Pull up strength in Ohm:
+ 1: 1.2 kOhm
+ 2: 1.8 kOhm
+ 3: 720 Ohm
+ 4: 2.7 kOhm
+ 5: 831 Ohm
+ 6: 1.08 kOhm
+ 7: 568 Ohm
Please do not use these custom enumerators 1 thru 7.
Instead say that the argument is given in ohms, so for
example:
bias-pull-up = <12000>;
Then translate this into the proper enumerator in your
driver instead.
Ok. The 3 bits in this enumeration correspond to enabling the 3 pull up
Rs (1.2k, 1.8k, 2.7k) in parallel, so the enum kind of make sense. But
sure I can change it to actual ohms and will error out in the driver if
specified value is not one of the 7.
No full example provided in the binding! This needs to
be there for understanding.
Ok Will add some examples.
Thanks,
Sherman
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
