Modify Tegra30 default USB2 phy_type to UTMI; this matches
power-on-reset defaults and is expected to be the common case.

The current implementation is likely an incorrect
carry-over from Tegra20, where USB2 does default to ULPI.

Signed-off-by: Eric Brower <[email protected]>
---
No upstream Tegra30 dts files reference USB2, so this should be a
safe change; anyone using an out-of-tree dts with USB2, sparsely
populated from the Tegra30 dtsi, may have an issue.

v2: modified register base address for USB2 bias pad regs

 arch/arm/boot/dts/tegra30.dtsi | 21 ++++++++++++++++-----
 1 file changed, 16 insertions(+), 5 deletions(-)

diff --git a/arch/arm/boot/dts/tegra30.dtsi b/arch/arm/boot/dts/tegra30.dtsi
index 2bd55cf..8bb8c46 100644
--- a/arch/arm/boot/dts/tegra30.dtsi
+++ b/arch/arm/boot/dts/tegra30.dtsi
@@ -669,7 +669,7 @@
                compatible = "nvidia,tegra30-ehci", "usb-ehci";
                reg = <0x7d004000 0x4000>;
                interrupts = <GIC_SPI 21 IRQ_TYPE_LEVEL_HIGH>;
-               phy_type = "ulpi";
+               phy_type = "utmi";
                clocks = <&tegra_car TEGRA30_CLK_USB2>;
                nvidia,phy = <&phy2>;
                status = "disabled";
@@ -677,12 +677,23 @@
 
        phy2: usb-phy@7d004000 {
                compatible = "nvidia,tegra30-usb-phy";
-               reg = <0x7d004000 0x4000>;
-               phy_type = "ulpi";
+               reg = <0x7d004000 0x4000 0x7d000000 0x4000>;
+               phy_type = "utmi";
                clocks = <&tegra_car TEGRA30_CLK_USB2>,
                         <&tegra_car TEGRA30_CLK_PLL_U>,
-                        <&tegra_car TEGRA30_CLK_CDEV2>;
-               clock-names = "reg", "pll_u", "ulpi-link";
+                        <&tegra_car TEGRA30_CLK_USBD>;
+               clock-names = "reg", "pll_u", "utmi-pads";
+               nvidia,hssync-start-delay = <9>;
+               nvidia,idle-wait-delay = <17>;
+               nvidia,elastic-limit = <16>;
+               nvidia,term-range-adj = <6>;
+               nvidia,xcvr-setup = <51>;
+               nvidia.xcvr-setup-use-fuses;
+               nvidia,xcvr-lsfslew = <2>;
+               nvidia,xcvr-lsrslew = <2>;
+               nvidia,xcvr-hsslew = <32>;
+               nvidia,hssquelch-level = <2>;
+               nvidia,hsdiscon-level = <5>;
                status = "disabled";
        };
 
-- 
1.8.1.5

--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to [email protected]
More majordomo info at  http://vger.kernel.org/majordomo-info.html

Reply via email to