Hi,
This series enables the 2 USB ports on the DRA7-evm.
NOTE: USB1 port is hard coded to work in peripheral mode and USB2 port
in host mode. This is due to missing ID pin interrupt in pre ver.E boards.
USB1 port doesn't in peripheral mode out of the box due to missing VBUS
detection
and mailbox write. To test this I had to do a manual write to enable VBUSVALID
in the USB_UTMI_OTG_STATUS register.
omapconf set bit 0x48880084 1
USB2 port works well in host mode.
Patches are based on 3.15-rc3.
cheers,
-roger
Roger Quadros (7):
ARM: dts: dra7-clock: Add "l3init_960m_gfclk" clock gate
ARM: DRA7: hwmod: Add SYSCONFIG for usb_otg_ss
phy: omap-usb2: Use generic clock names "wkupclk" and "refclk"
ARM: dts: omap4+: Add clocks to USB2 PHY node
phy: omap-usb2: Add clock names to Documentation binding
ARM: dts: dra7: Add USB related nodes
dts: dra7-evm: add USB support
Documentation/devicetree/bindings/phy/ti-phy.txt | 7 ++
arch/arm/boot/dts/dra7-evm.dts | 24 ++++
arch/arm/boot/dts/dra7.dtsi | 149 +++++++++++++++++++++++
arch/arm/boot/dts/dra7xx-clocks.dtsi | 12 +-
arch/arm/boot/dts/omap4.dtsi | 2 +
arch/arm/boot/dts/omap5.dtsi | 2 +
arch/arm/mach-omap2/omap_hwmod_7xx_data.c | 22 ++--
drivers/phy/phy-omap-usb2.c | 8 +-
8 files changed, 210 insertions(+), 16 deletions(-)
--
1.8.3.2
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
